DP-101ZL3-M-P

 Dual Display Digital Pressure Sensor [For Gas]

 ● IO-Link compatible

 ● Pressure Range : -100.0 to +100.0 kPa

 ● Pressure Port : M5 Female Thread

 ● Output : PNP & IO-Link Baud Rate COM3 supported

 ● Connector Type

Attributes

  • Sensor Type

    Gauge Pressure (For Gas)
  • Shape

    Square
  • Applicable fluid

    Non-corrosive gas
  • Pressure Range

    -100.0 to +100.0 kPa
  • Pressure Port

    M5 Female Thread
  • Output

    PNP & IO-Link Baud Rate COM3 supported
SKU: DP-101ZL3-M-P Category:
Type Gauge Pressure (For Gas) Shape Square Applicable fluid Non-corrosive gas
Pressure Range -100.0 to +100.0 kPa Pressure with standability 500 kPa Pressure Port M5 Female Thread
Selectable Unit kPa Digital Display Yes Output PNP & IO-Link Baud Rate COM3 supported
Output Operation NO / NC Selectable Input supply 12 to 24 VDC Connection Type Connector Type
Response Time 2.5 ms Enclosure PBT Protection
Particular Characteristics 4 digits + 4 digits 3-color LCD Display

Field data was collected and accumulated for “preventive maintenance” and “operation monitoring”. An analysis of such field data requires high-level know-how and time, causing a burden on people responsible for the production site management. The Self-Monitoring Sensor manufactured by Panasonic is capable of reporting sensor data and its own state to the host device through the I/O Link master. With the Self-Monitoring Sensor, you can immediately judge the state of the sensor and easily identify the cause of failure. Thus, this sensor contributes to the reduction of the burden experienced by the client in collecting and analyzing data.

Improvements to the digital display deliver a wide viewing angle along with increased clarity. The display pressure range and set pressure range have also been increased. Enhanced power circuitry Addition of a reverse polarity protection circuit to the transistor output circuit. Equipped with a 30 mm 1.181 in the square compact-sized dual display. The current value and the threshold value can be checked at the same time, so the threshold value can be set and checked smoothly without switching to another screen mode. ON / OFF operations still continue while the threshold values are being set, so setting to the same sensitivity as dial control-type sensors is possible. The key lock function is equipped as well. The main display changes color in line with changes in the status of output ON / OFF operation, and it also changes color while the setting is in progress. The sensor status can therefore be understood easily, and operating errors can be reduced. Three output modes are suitable for a wide range of applications.

Download Datasheet
Download Catalogue
Sit amet, consectetur adipiscing elit. Ut elit
Lorem ipsum dolor sit amet, consectetur adipiscing elit.
20+ Years of Industrial Experience
Lubi Electronics
Logo